SKU / Product Info	Quantity
LSTHD8 Strap Length: 18-5/8" Rim Joist: 32-1/8" le: 8" Req'd Nails 20-16d Sinkers Non Cracked Midwall: 3115 Corner: 2700 Endwall: 1690 Cracked Midwall: 2675 Corner: 2320 Endwall: 1455

Quick Overview

Use all specified fasteners. See General Notes.
Install before concrete pour with a StrapMate, or other holding device.

Nail strap from the bottom up.

Strap may be bent one full cycle (bent horizontal 90° then bent vertical) to aid wall placement, but may cause spalling behind the strap. If the spall is 1" or less, measured from the embedment line to the bottom of the spall, full loads apply. 1" to 4" spalls for LSTHD8 achieve 0.9 times table loads. STHD10 and STHD14 achieve full load for spalls less than 4". Any portion of the strap left exposed should be protected against corrosion.

Other than where noted in the two-pour detail, do not install where:

(a) a horizontal cold joint exists within the embedment depth between the slab and foundation wall or footing beneath, unless provisions are made to transfer the load, or the slab is designed to resist the load imposed by the anchor; or

(b) slabs are poured over concrete block foundation walls.

Additional studs attached to the shearwall studs or post may be required by the Designer for wall sheathing nailing.

Wood shrinkage after strap installation across horizontal members may cause strap to buckle outward.

Interested in this item or want more information?
Call Mon. through Fri. 7:30 AM - 4:00 PM PST
Phone: (657) 777-3411
Email: sales@48ws.com

Can't find what you want? Give us a call and we can help you find it.

Details

The STHD is an embedded strap-tie holdown offering high load capacity and a staggered nail pattern to help minimize splitting. The STHD incorporates many features that aid correct installation and improve performance. When installed on the forms with the StrapMate® strap holder the unique design of the STHD delivers enhanced stability before and during the pour to help prevent both parallel and perpendicular movement (relative to the form). This results in accurate positioning of the strap and reduced possibility of spalling.

Additional Information

Manufacturer: Simpson Strong-Tie

For More Information on the Tension Loads for STHD Installations:, [Click Here] to Link to Manufacturer Web Site

Search: